Featured Stories

RSS

How will this image be used? Do I anticipate any changes? What are your tolerance requirements? All these questions are paramount in determining the successful path of the data output and each are mutually exclusive of one another.

The frictional behavior of wet clutches for applications such as automatic transmissions have a controlling influence over the function of the entire system during operation.

Height gages have achieved a nearly universal presence in the quality control world. It is rare to see a QC department without at least one or two of these instruments. This commonality makes it easy to overlook just how accurate and flexible these devices are. They measure much more than the term “height gage” would imply.

You may not have noticed it, but there’s been a trend creeping into most of our lives. Its origins are rooted in consumer expectation. Consumers want to hold up their cell phones and snap the perfect selfie with the sun setting over the beach behind them. And they want to create panorama shots that challenge the best of wide angle lenses.

Have you heard of Line Confocal Imaging (LCI)? Perhaps not, since the technology is relatively new to the already high-tech, high-resolution 3D measurement industry. Companies like Axiom Optics are dipping their toes in the water with STIL’s line of noncontact, chromatic confocal sensors. 

With the continually increasing demand on framerates, bit depths, and resolution, interface standards must adapt to these changes with new ways to transfer data with increased speed and robustness.

High bandwidth is essential when transmitting big data volumes in image processing systems. However, available interface technologies like GigE or CoaXPress are the bottleneck when talking about bandwidth. By pre-processing the image in the camera and applying data compression technologies this bottleneck can be mitigated.

ECR Engines, a division of Richard Childress Racing, is in the business of extracting maximum performance from conventional, push-rod 5.87 Liter V8 engines for NASCAR competition.

It’s certainly not news that more and more gages are being forced out onto the shop floor. Tight tolerance measurements that were once performed by a trained inspection technician are now being done right next to the machining center, most likely by the machine tool operator.

Of all of the changes in ISO 9001:2015, the one that users typically mention as being the one they are most concerned about is Management Commitment (clause 5.1.1). Maybe it is because the change has been emphasized so much in communication and training.